Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 axis/spindle %3 not programmable in the channel
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Mistake in programming: The axis/spindle cannot be programmed in the channel at this time. This alarm can occur when the axis/spindle is being used by another channel or by the PLC.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program, use "GET()".
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved