16750
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 axis %3 SPCON not programmed
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
For the programmed function (rotary axis, positioning axis), the spindle must be in position control mode.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Program position control of the spindle with SPCON in the previous block.
Clear alarm with NC START or RESET key and continue the program.
1-789
© Siemens AG 2005 All Rights Reserved