16720
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 axis %3 thread lead is zero
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
No lead was programmed in a thread block with G33 (thread with constant lead) or G331 (rigid tapping).
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
The thread lead must be programmed for the specified geometry axis under the associated interpolation parameters.
X -> I Y -> J Z -> K
Clear alarm with NC START or RESET key and continue the program.
1-786
© Siemens AG 2005 All Rights Reserved