16424
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 coordinate %3 programmed repeatedly in the block
%1 = Channel number %2 = Block number, label %3 = Coordinate
It is not allowed to program a coordinate of the 2nd contact point of the tool for description of the tool orientation several times in one block.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
1-777
© Siemens AG 2005 All Rights Reserved