Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 invalid index for tool fine compensation
%1 = Channel number %2 = Block number, label
Mistake in programming: The 2nd parameter in the PUTFTOC command indicates for which tool parameter the value is to be corrected (1 - 3 tool lengths, 4 tool radius). The programmed value is beyond the permitted range.
Permissible values are 1 - 4 if on-line tool radius compensation is allowed (see machine data ONLINE_CUTCOM_ENABLE), otherwise values 1 - 3.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program: Length 1 - 3 or 4 permissible for radius.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved