Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 invalid value for lifting direction
%1 = Channel number %2 = Block number, label
During the "rapid lift from contour" (keyword: LIFTFAST), a code value for the lifting direction (keyword: ALF=...) which lies outside the permissible range (permissible value range: 0 to 8) was programmed .
With active cutter radius compensation:
Code numbers 2, 3 and 4 cannot be used in G41
Code numbers 6, 7 and 8 cannot be used in G42 because they code the direction to the contour.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Program the lifting direction under ALF=... within the permissible limits.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved