Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 illegal incremental programming in axis %3
%1 = Channel number %2 = Block number, label %3 = Axis
The first axis programming after "search to block end point" is performed incrementally. This is not allowed in the following situations:
After searching the target a transformation change has taken place.
A frame with rotation component is active. The programmed axis is involved in the rotation.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Find search destination in which the axes are programmed using an absolute reference. Deactivate adding of the accumulated search position with $SC_TARGET_BLOCK_INCR_PROG = FALSE.
Use search run with calculation "at contour".
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved