Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 SETINT instruction with invalid priority
%1 = Channel number %2 = Block number, label
The NCK input number must lie between 1 and 8. It is assigned a priority from 0 to 128 (1 is the highest priority) in the SETINT instruction with the keyword PRIO = ... .
Example:
If NCK input 5 changes to "1" the subroutine LIFT_Z should be started with the highest priority.
N100 SETINT (5) PRIO = 1 LIFT_Z
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Program the priority of the NCK input with a value of not less than 1 or greater than 128. Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved