14415 |
Channel %1 block %2 tangent control: changeover geometry/channel axis not allowed |
Parameters: |
%1 = Channel number %2 = Block number, label |
Definitions: |
An assignment change of the geometry axes to channel axes is not permitted with active tangential control. |
Reactions: |
- Correction block is reorganized. - Interface signals are set. - Alarm display. |
Remedy: Program Continuation: |
Change part program and delete active tangential control with TANGDEL. Clear alarm with NC START or RESET key and continue the program. |
© Siemens AG 2005 All Rights Reserved