Channel %1 block %2 polar coordinates programmed incorrectly

%1 = Channel number %2 = Block number, label

The end point of the displayed block has been programmed both in the polar coordinate system (with AP=..., RP=...) and in the Cartesian coordinate system (axis addresses X,

Y,...).

-    Correction block is reorganized.

-    Interface signals are set.

-    Alarm display.

Correct the NC part program - the axis motion may be specified in one coordinate system only.

Clear alarm with NC START or RESET key and continue the program.

© Siemens AG 2005 All Rights Reserved