Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 illegal plane change for tool with diameter component
%1 = Channel number %2 = Block number, label
If a tool has a wear or length component which is evaluated as a diameter for the facing axis (bit 0 and/or bit 1 in MD $MC_TOOL_PARAMETER_DEF_MASK is set) and bit 2 of this MD is also set, this tool may only be used in the plane active on tool selection. A plane change results in an alarm.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Reset bit 2 in MD $MC_TOOL_PARAMETER_DEF_MASK.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved