14198

Channel %1 block %2 illegal change of tool direction with tool offset

Parameters:

%1 = Channel number

%2 = Block number, label

Definitions:

If an offset is active in the tool direction, block change is not possible if this would change the assignment of the offset axes to the channel axes (plane change, tool change, cutter <=> turning tool, geometry axis replacement).

Reactions:

-    Correction block is reorganized.

-    Local alarm reaction.

Remedy:

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm at block end.

Modify part program.

Reduce the offset in tool direction to zero.

Program Continuation:

Clear alarm with NC START or RESET key and continue the program.