14180 |
Channel %1 block %2 H number %3 is not defined |
Parameters: |
%1 = Channel number %2 = Block number, label %3 = H number of ISO mode |
Definitions: Reactions: |
The specified H number is not assigned to a tool (ISO_2). - Correction block is reorganized. - Local alarm reaction. |
Remedy: Program Continuation: |
- Interface signals are set. - Alarm display. - NC Stop on alarm at block end. Modify part program. Clear alarm with NC START or RESET key and continue the program. |
© Siemens AG 2005 All Rights Reserved
1-602