14165

Channel %1 block %2 selected H number %3 does not match tool %4

Parameters:

%1 = Channel number

%2 = Block number, label

%3 = H/D number of ISO mode

%4 = Tool number

Definitions:

When an H or D number is programmed in ISO_2 mode, it must be available in the active tool. The active tool may also be the last loaded tool on the master spindle or master toolholder. If there is no H or D number on this tool, this alarm will be output.

Reactions:

-    Correction block is reorganized.

-    Local alarm reaction.

Remedy:

Program Continuation:

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm at block end.

Set H number correctly.

Clear alarm with NC START or RESET key and continue the program.