Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 The amount of fine correction in parameter %3of the orientable toolholder %4 is too large
%1 = Channel number %2 = Block number, label
%3 = Invalid parameter of the orientable toolholder %4 = Number of the orientable toolholder
The maximum permissible value of the fine correction in an orientable toolholder is limited by the machine data $MC_TOCARR_FINE_LIM_LIN for linear variables, and by the machine data $MC_TOCARR_FINE_LIM_ROT for rotary variables. The alarm can only occur if the setting data $SC_TOCARR_FINE_CORRECTION is not equal to zero.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Enter a valid fine correction value.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved