14123
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 nutation angle of the cone too small
%1 = Channel number %2 = Block number, label
With taper circumference interpolation, the programmed opening angle of the taper must be greater than the half of the angle between the start and end orientation. Otherwise, a taper cannot be defined.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
1-569
© Siemens AG 2005 All Rights Reserved