14035 |
Channel %1 block %2 involute: start point invalid |
Parameters: |
%1 = Channel number %2 = Block number, label |
Definitions: |
With involute interpolation, the start point of the involute must be outside the basic circle. The programmed center point or radius must be adapted accordingly. |
Reactions: |
- Correction block is reorganized. - Interface signals are set. - Alarm display. |
Remedy: Program Continuation: |
Modify part program. Clear alarm with NC START or RESET key and continue the program. |
© Siemens AG 2005 All Rights Reserved