14026 |
Channel %1 block %2 motion synchronous action: invalid polynomial number in the FCTDEF command |
Parameters: |
%1 = Channel number %2 = Block number, label |
Definitions: |
An FCTDEF command was programmed with a polynomial number that exceeds the maximum value set in $MC_MM_NUM_FCTDEF_ELEMENTS. |
Reactions: |
- Interpreter stop - NC Start disable in this channel. |
Remedy: Program Continuation: |
- Interface signals are set. - Alarm display. Modify part program. Clear alarm with the RESET key. Restart part program |
© Siemens AG 2005 All Rights Reserved