14000 |
Channel %1 block %2 illegal end of file |
Parameters: |
%1 = Channel number %2 = Block number, label |
Definitions: |
Part program was not terminated with M30, M02 or M17. This error is also signalled at the host if the environment variables NCPROG or NCUPROG have been set to a non-existing file. |
Reactions: |
- Interpreter stop - NC Start disable in this channel. |
Remedy: |
- Interface signals are set. - Alarm display. End part program with M30, M02 or M17 and start part program. Check environment variables NCPROG and NCUPROG at the host. |
Program Continuation: |
Clear alarm with the RESET key. Restart part program |
© Siemens AG 2005 All Rights Reserved