Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 no radius programmed for cylinder interpolation activation/ deactivation
%1 = Channel number %2 = Block number, label
When programming G07.1 (cylinder interpolation TRACYL), no cylinder radius has been programmed. Selection of the cylinder interpolation (TRACYL) with G07.1 C <cylinder radius> deselect with G07.1 C0. For "C" the name of the rotary axis defined in the TRACYL machine data has to be programmed.
- Correction block
- Interface signals are set.
- Alarm display.
G07.1 block, program the cylinder radius under the name of the rotary axis for the cylinder interpolation.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved