Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 multiple ISO_2/3 macro or cycle calls in the block
%1 = Channel number %2 = Block number, label
A mixture of cycle and macro calls are programmed in a block, e.g. cycle calls with G81 -G89 together with an M macro in the block or a G65/G66 macro call together with M macros in the block.
G05, G08, G22, G23, G27, G28, G29, G30, G50.1, G51.1, G72.1, G72.2 functions (ISO mode) also execute subroutine calls. Only one macro or cycle call can appear in an NC block.
- Correction block
- Interface signals are set.
- Alarm display.
Deactivate modal cycles or modal macro calls if one of the above mentioned G functions has been programmed.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved