Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 invalid nesting of control structures
%1 = Channel number %2 = Block number
Error in program run: Opened control structures (IF-ELSE-ENDIF, LOOP-ENDLOOP etc.) are not terminated or there is no beginning of loop for the programmed end of loop. Example:
LOOP ENDIF ENDLOOP
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Correct part program in such a way that all opened control structures are also terminated. Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved