Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 parameter %3 no longer possible
%1 = Channel number %2 = Block number, label %3 = Source string
An attempt has been made to transfer actual parameters although axis parameters located before them have not been assigned. For procedure or function calls, assignment of parameters that are no longer required can be omitted, if subsequently no further parameters are to be transferred. Example: N10 FGROUP(X, Y, Z, A, B) ; max. 8 axes possible The following call-by-value parameters would then be initialized with zero because the space-dependent assignment has been lost on account of the omitted axis parameters.
Axes that can be omitted and following parameters do not occur in the predefined procedures and functions.
- Correction block
- Interface signals are set.
- Alarm display.
Press the NC Stop key and select the function "Correction block" with the softkey PROGRAM CORRECT. The correction pointer positions on the incorrect block. In predefined procedures and functions either remove the following parameters or transfer any preceding axis parameters. In user-defined procedures and functions, parameter transfer must be programmed in accordance with the instructions given in the machine manufacturer's programming guide.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved