Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 curve table %3: no contour defined
%1 = Channel number %2 = Block number, label %3 = Number of curve table
No movement for the leading axis was programmed between CTABDEF and CTABEND. A curve table is not permitted without a contour.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Correct the part program and start it again.
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved