10943 |
Channel %1 block %2 curve table %3: direction reversal of lead value in the block not allowed |
Parameters: |
%1 = Channel number %2 = Block number, label %3 = Number of curve table |
Definitions: |
The conditions for converting a programmed contour to a curve table were not fulfilled in this block. |
Reactions: |
- Interpreter stop - NC Start disable in this channel. |
Remedy: Program Continuation: |
- Interface signals are set. - Alarm display. Correct the part program and start it again. Clear alarm with the RESET key. Restart part program |
© Siemens AG 2005 All Rights Reserved