Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2: Curve table %3: NC SRAM memory full, type %4
%1 = Channel number %2 = Block number, label %3 = Number of curve table %4 = Object type
Insufficient free dynamic memory during curve table definition.
The object type parameter specifies for which curve table object the memory will not suffice:
1: Number of curve tables too small (MD $MN_MM_NUM_CURVE_TABS)
2: Number of linear curve table segments too small (MD $MN_MM_NUM_CURVE_SEG_LIN)
3: Number of polynomial curve table segments too small (MD $MN_MM_NUM_CURVE_SEGMENTS)
4: Number of curve table polynomials too small (MD $MN_MM_NUM_CURVE_POLYNOMS)
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Delete curve tables that are no longer required, or reconfigure the disk space for the curve tables. The curve table definition process now has to be repeated; see machine data: MN_MM_NUM_CURVE_TABS, MD MN_MM_NUM_CURVE_SEGMENTS, MN_MM_NUM_CURVE_SEG_LIN,
MN_MM_NUM_CURVE_POLYNOMS.
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved