Program Continuation:

Channel %1 block %2 chamfer or fillet has to be reduced

%1 = Channel number %2 = Block number, label

This alarm is output, if at least one of the relevant blocks when inserting chamfers or radii is so short, that the contour element to be inserted must be reduced against its originally programmed value. The alarm occurs only if bit 4 is set in the machine data $MN_ENABLE_ALARM_MASK. Otherwise, the chamfer or radius is adapted without an alarm being output.

-    Local alarm reaction.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm at block end.

Modify NC program of continue program without modifications after CANCEL and Start or with Start alone.

Clear alarm with the Delete key or NC START.


© Siemens AG 2005 All Rights Reserved