10882
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 activation of chamfers or radii (non-modal) without traversing movement in the block
%1 = Channel number %2 = Block number, label
No chamfer or radius has been inserted between 2 linear or circle contours (edge breaking) because:
There is no straight line or circle contour in the plane There is a movement outside of the plane A plane change has taken place
The permissible number of dummy blocks without traversing information has been exceeded.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Correct the part program according to the above error description or change the number of dummy blocks in the channel-specific MD CHFRND_MAXNUM_DUMMY_BLOCKS to comply with the maximum number allowed for in the program.
Clear alarm with NC START or RESET key and continue the program.
1-376
© Siemens AG 2005 All Rights Reserved