10860 |
Channel %1 block %2 feedrate not programmed |
Parameters: |
%1 = Channel number %2 = Block number, label |
Definitions: |
Reason: |
Reactions: |
In the displayed block, an interpolation type other than G00 (rapid traverse) is active. The F value has not been programmed. Path feed F is active, on change between linear and revolutional feedrate, F has not been programmed again. The modal feed for corner/chamfer (FRCM) is active, on change between linear and revolutional feedrate FRCM has not been programmed again. - Correction block is reorganized. - Local alarm reaction. |
Remedy: |
- Interface signals are set. - Alarm display. Program feedrate in accordance with the interpolation type. G93: The feedrate is specified as a time-reciprocal value under address F in [1/min]. G94 and G97: The feedrate is programmed under address F in [mm/min] or [m/min]. G95: The feedrate is programmed as revolutional feedrate under address F in [mm/ revolution]. G96: The feedrate is programmed as cutting rate under address S in [m/min]. It is derived from the current spindle speed. |
Program Continuation: |
Clear alarm with NC START or RESET key and continue the program. |
© Siemens AG 2005 All Rights Reserved