Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 second block missing during linear programming with angles
%1 = Channel number %2 = Block number, label
The second block is missing during programming of two straight lines with angle specification. This situation only occurs if the first subblock is also the last block of a program, or if the first subblock is followed by a block with a preprocessor stop.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved