10783 |
Channel %1 block %2 tool radius compensation type requires orientation transformation |
Parameters: |
%1 = Channel number %2 = Block number, label |
Definitions: |
This alarm occurs, if an attempt is made to activate a tool radius compensation which must enable a tool orientation change and the _Orientation transformation_ option is not available. This alarm can only occur if one of the following G code is active in the G code group 22: CUT3DC CUT3DCC CUT3DCCD |
Reactions: |
- Correction block is reorganized. - Local alarm reaction. |
Remedy: |
- Interface signals are set. - Alarm display. - NC Stop on alarm at block end. Modify part program Install "Orientation transformation" option |
Program Continuation: |
Clear alarm with NC START or RESET key and continue the program. |
© Siemens AG 2005 All Rights Reserved