Channel %1 block %2 impermissible change of a turning or grinding tool with active tool radius compensation

%1 = Channel number %2 = Block number, label

A tool change on which the edge offset (difference between edge center and edge reference point) changes, is only permissible in straight and polynomial blocks.

It is impermissible in circular blocks, involute blocks and in blocks including rational polynomials with maximum permissible numerator and denominator degrees.

-    Correction block is reorganized.

-    Local alarm reaction.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm at block end.

Continue machining with CANCEL and Start.

Modify part program.

Set setting data $SC_STOP_CUTCOM_STOPRE to FALSE.

Clear alarm with NC START or RESET key and continue the program.

© Siemens AG 2005 All Rights Reserved