Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 preprocessing stop with active tool radius compensation
%1 = Channel number %2 = Block number, label
If a preprocessing stop is detected with active tool radius compensation (either programmed by the user or generated internally) and the setting data $SC_STOP_CUTCOM_STOPRE is set, then this warning is issued because in this situation machine movements which were not intended by the user can occur (termination of radius compensation and new approach).
- Alarm display.
- NC Stop on alarm at block end.
Continue machining with CANCEL and Start.
Modify part program.
Set setting data $SC_STOP_CUTCOM_STOPRE to FALSE.
Clear alarm with the Delete key or NC START.
© Siemens AG 2005 All Rights Reserved