Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 processing with tilt angle unequal 0 not possible
%1 = Channel number %2 = Block number, label
When face milling with a torus milling cutter, the tilt angle must be 0 if the surface normal vector and the tool orientation include an angle that is less than the limiting angle given by the machine data 21082 CUTCOM_PLANE_ORI_LIMIT, i.e. in this case only the lead angle may be unequal to 0.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program. If necessary, use another tool (ball end mill).
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved