Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 selection of the tool radius compensation only possible in linear block
%1 = Channel number %2 = Block number, label
Selection of cutter radius compensation with G41/G42 may only be performed in blocks where the G function G00 (rapid traverse) or G01 (feed) is active.
In the block with G41/G42, at least one axis in the plane G17 to G19 must be written. It is always advisable to write both axes because, as a rule, both axes are traversed when selecting the compensation.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Correct the NC program and put the compensation selection in a block with linear interpolation.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved