Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 WAB end position not clear
%1 = Channel number %2 = Block number, label
In the WAB block and in the following block, the position has been programmed perpendicular to the machining direction. In the WAB block, no position has been indicated in the machining plane.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program. Either remove the position data for the infeed axis from the WAB block or the following block, or program a position in the machining plane in the WAB block as well.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved