Remedy:
Program Continuation:
Option 'activation of more than %1 axes' not set
%1 = Number of axes
More machine axes have been defined through the channel-specific MD 20070 AXCONF_MACHAX_USED than are allowed in the system.
- NC not ready.
- Mode group not ready, also effective for single axes
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. The sum of all axes that have been configured through the channel-specific MD 20070
AXCONF_MACHAX_USED, must not exceed the maximum number of axes (dependent on configuration -> option, basic version: 4 axes).
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved