Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 tool change not possible. Invalid magazine location no. %3 in buffer magazine
%1 = Channel ID
%2 = Block number, label
%3 = Magazine location number
The desired tool change is not possible. The specified magazine location is either toolholder/spindle or empty.
Only the numbers of the buffer that are not toolholder/spindle may be programmed with the NC command TCI, i.e. the location number of a gripper is allowed.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Check whether the magazine data ($TC_MPP1) have been defined correctly.
Check whether the alarm-causing program command _ e.g. TCI _ has been programmed correctly.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved
1-180