6441
Definitions:
Reactions:
Remedy:
Program Continuation:
Writing of $P_USEKT not allowed.
An attempt was made to write the value of $P_USEKT. This is not possible since programming T= 'location number' with automatic setting of $P_USEKT is active.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Make sure of how the NC is supposed to be configured! (see bit16 and bit22 in $MC_TOOL_MANAGEMENT_MASK)
Tool change with "Reject tool" is configured. If you now try to start this program on NC control with T-location number' with automatic setting of $P_USEKT this will not be possible.
Either run the part program on the appropriate NC control or edit the part program. Clear alarm with the Delete key or NC START.
1-178
© Siemens AG 2005 All Rights Reserved