6434

Parameters:

Definitions:

Reactions:

Remedy:

Program Continuation:

Channel %1 block %2 NC command SETMTH not allowed because tool holder function not active

%1 = Channel number %2 = Block number, label

No master toolholder has been defined for the initial state

($MC_TOOL_MANAGEMENT_TOOLHOLDER = 0), therefore no toolholder is available. The NC command SETMTH has neither been defined. In this setting, the tool change is carried out referring to the master spindle. The master spindle is set with SETMS.

-    Correction block is reorganized.

-    Local alarm reaction.

-    Interface signals are set.

-    Alarm display.

Correct the NC program (delete or replace SETMHT) or enable toolholder function via machine data.

Clear alarm with NC START or RESET key and continue the program.

1-177

© Siemens AG 2005 All Rights Reserved