Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 tool move not possible. Empty location for tool %2 Duplo no. %3 on magazine %4 not available.
%1 = Channel ID %2 = String (identifier)
%3 = Duplonummer %4 = Magazine number
The desired tool motion command - triggered from the MMC or PLC - is not possible. The tool cannot be moved into the specified tool magazine. There is no appropriate location for this tool.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check whether the magazine data have been defined correctly (e.g. the magazine must not be disabled).
Check whether the tool data are correctly defined (for example, the tool location type must match the location types allowed in the magazine).
Check whether there is still room in the magazine to add another tool; there may not be due to operating procedures.
Check whether a location type hierarchy is defined and whether it, for example, does not allow insertion of a type 'A' tool in a free location with type 'B'.
Clear alarm with the Delete key or NC START.
© Siemens AG 2005 All Rights Reserved
1-168