Channel %1 tool %2 cannot be placed in magazine %3 on location %4. Invalid definition of magazine!

%1 = Channel ID %2 = String (identifier)

%3 = Magazine number

%4 = Magazine location number

A tool change request or a verification request was issued to put the tool in a location which does not satisfy the prerequisites for filling.

The following causes for the error are possible:

Location is blocked or not free!

Tool type does not match the location type!

Tool possibly too large, adjacent locations are not free!

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

Check whether the magazine data are correctly defined (especially the location type). Check whether the tool data are correctly defined (especially the location type).

Clear alarm with the RESET key. Restart part program

© Siemens AG 2005 All Rights Reserved