Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 invalid transformation type in transformation no. %3
%1 = Channel number %2 = Block number, label %3 = Transformation number
An invalid, i.e. undefined, number was entered in one of the machine data TRAFO_TYPE_1 ... TRAFO_TYPE_8. This alarm also occurs if a certain type of transformation is only impossible on the type of control used (e.g. 5-axis transformation on a SINUMERIK 802D).
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Enter a valid transformation type.
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved