4215 |
Channel %1 spindle %2 declaration as modulo axis missing |
Parameters: |
%1 = Channel number |
Definitions: Reactions: |
%2 = Axis name, spindle number The spindle functionality requires a modulo axis (positions in [deg],.). - Mode group not ready. - Channel not ready. - NC Start disable in this channel. |
Remedy: |
- Interface signals are set. - Alarm display. - NC Stop on alarm. Please inform the authorized personnel/service department. Set MD "ROT_IS_MODULO". |
Program Continuation: |
Switch control OFF - ON. |
© Siemens AG 2005 All Rights Reserved
1-110