Remedy:
Program Continuation:
Channel %1 axis %2 high-speed punching/nibbling not possible via link
%1 = Channel number
%2 = Axis name, spindle number
An attempt was made to activate high-speed nibbling or punching for an axis programmed on a different NCU than the drive.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
- Channel not ready.
High-speed nibbling and punching is only supported on one NCU.
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
© Siemens AG 2005 All Rights Reserved