2130

Definitions:

Reactions:

Remedy:

Program Continuation:

5V/24V encoder or 15V D/A converter undervoltage

A failure has occurred in the power supply (FM357-2) to the encoder (5V/24V) or D/A converter (+/-15V).

-    NC not ready.

-    The NC switches to follow-up mode.

-    Mode group not ready, also effective for single axes

-    NC Start disable in this channel.

-    Axes of this channel must be re-referenced.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

Please inform the authorized personnel/service department. Check the encoder and cable for short-circuits (the fault should not occur when you remove the cable). Check the power feeder line.

Switch control OFF - ON.

1-29

© Siemens AG 2005 All Rights Reserved