Sinumerik Sinamics Battery Replacement

3v Lithium battery is located at the bottom of the NCU in the module with the fan (see picture).

Proceed as follows

1. Gently push the dual fan/battery module backwards (by pressing on the pressure point) to
   release the module from its front interlock (snap-in hooks).2. Tilt the dual fan/battery module forwards at an angle and pull out the plastic guide from
   the Control Unit cutout.
2. Remove the battery by first removing the plug connector and then taking out the battery.
3. Connect the cable plug connector of the new battery to the mating connector in the dual
   fan/battery module and push the battery in.

??

1. Replace the module.
2. The electrical connection between the double fan/battery module and the control unit is automatically set.

NOTICE To avoid loss of data, the dual fan/battery module must be replaced during operation. When doing this, observe that the Control Unit can only be operated for a maximum of 1 minute without fans. If this time is exceeded, the Control Unit will shut itself down.